Rotary Charcoal Grinders

I have been putting off making a good charcoal grinder for a long time, as I did not have a way to weld the heavy steel parts used on a Gilmore rotary grinder. I tried a lot of other ideas, and I had no luck. With a new welder, I was finally able to give it a go, and it works great! Here is a quick video

I am going to eventually mount it up higher with an angled hardware cloth chute to sort out the fines. It runs on a 1/2 hp motor that only draws about 130 watts when unloaded -didnt check it while it was grinding, but it should run on my charcoal generator without any trouble.

Here are some other posts with videos of similar grinders:

Anyone that I missed who has a video of a grinder in action, please post it here!

11 Likes

Hi Carl,

That is a nice grinder. Good work!

Solar-Fuel, onward.

5 Likes

Nice. To sift out the fines, use a rotating trummel or cast the charcoal onto the upper end of a screen tilted at a 45 degree angle. The dust will fall through and the engine char will not. Better yet, mount the grinder above an inclined screen and do it all in one operation.
Gary in PA

3 Likes

You guys who have already built grinders, how much space have you left between the nubs on the drum and the stationary fingers?

1 Like

Andy, I TIG welded some RR spike pieces to a 3" pipe, and then used RR spikes for the teeth of the comb.! Here is a photo of Gary’s set-up, I believe.
Gilmore_grinder
Gilmore_grinder|175x275
Grinder_parts
Looking at the second photo (the one I built), I would guess 1/8" on either side of the tooth for clearance?
Mine is hand cranked, and is located near the path from the house to the shop. I hold my breath, crank for a minute or so, and continue on to where I was going.

8 Likes

Yep, 1/8" or so each side.

7 Likes

Ok, here is my grinder set up in its home location

10 Likes

Andy; If you put another β€œbeer” sign on top of the 2x4 that hold the sifter, would it act as a chimney and pull the dust up and away? Tomc

2 Likes

Andy that’s a nice grinder!